CASE FOR FLASH DRIVE IN THE STYLE OF LEGO

Send

In the life of a flash drive, sometimes a moment comes when its body begins to break. Unfortunately, this situation also happened to me. Everything would be fine, but the lack of a case on a flash often leads to a reduction in life or a complete exit from a standing device. At first there was an option to wind up everything with tape or electrical tape, but many flash drives heat up during operation, and the glue on these tapes is not heat-resistant. And suddenly the idea occurred to me not only to protect the device, but also to provide a creative look. So let's get started!
We will need:
* a few LEGO blocks and plates for them
* candle or lighter to heat the instrument
* matches
* knife (or medical scalpel)
* fine sandpaper on a bar
* flash drive (preferably small)
* Super-adhesive based on cyanoacrylate (can be bought at a hardware store)
* remnants of the past building (if necessary)
* gloves (for glue protection)

First you need to prepare a cube. If your flash drive is small, then you can use the 4X2 block, if it is simple, then you have to pick up another cube. Next, with a hot knife we make a neat hole for the USB connector.

It should be no more and no less than a connector, otherwise the product will look ugly and the flash drive will hang in the case.

Through the hole, cut out some of the insides in the LEGO block so that there is room for a flash inside. If possible, you can modify the file, but do not process the product with a flash drive, because This threatens to break the entire device.