How to make a bracelet from pins

Pin
Send
Share
Send

When gray cloudy days come, I so want to cheer up, even with bright colors in jewelry! Bright, yellow as the sun, multi-colored bracelet - it immediately makes you come to life and smile. Moreover, to do it very simply and not for long - can be done in the evening.

You will need:
Pins - 35-40 pcs. (these are 4 sets) 3,5 cm long - the smallest;
Elastic thread;
Large beads of 2 colors: yellow opaque and green translucent and medium-sized beads orange.
1) Measure the gum thread - its length should be a double girth of the wrist plus 3 cm on each side of the tie.

2) We begin the collection of the bracelet. To do this, string a gum on a gum thread, leaving equal ends of the gum thread on both sides.

3) String the beads and beads on pins, alternating colors. Then we squeeze the pin latch with pliers so that the needle does not pop out while wearing the bracelet.
String the pin, then string the bead on each side and again the pin. The bracelet will be more beautiful if you alternate the latches of the pins from different sides of the bracelet, as can be seen in the photo.

4) We complete our bracelet. To do this, thread the ends of the gum thread from the last pin through the holes of the first pin and tie them into two knots.

5) We try on a hand and see that the bracelet fits tightly on the hand without gaps and holes, does not creep on the wrist. If there are not enough pins, we untie the bracelet, add the pins and fix it permanently on 3 knots. Also, for greater reliability of the bracelet, you can pass a wide elastic band of 2.5-3 cm between the pins between the pins and sew its ends.

Pin
Send
Share
Send

Watch the video: 19 DIY JEWELRY IDEAS FOR KIDS (May 2024).