Puppy

Pin
Send
Share
Send

The puppy figurine is made of two separate parts. This will not be a flat toy, but a toy that itself can stand on the table without outside help.
First, the head part is executed. Fold the square in half, lay it in front of you on the table with the wide side - fold - up. First, give the head a more rounded shape. To do this, bend one layer of paper forward at the bottom corner - make a small bend outward. Fold the second layer of paper in the same direction, but load it inward, between the layers. So on the bottom of the dog’s face two new angles formed. Then you need to bend to the center two lateral corners - the blanks for the ears. Each fold should start from the bottom new corner and go through the middle of the side, dividing the upper edge of each side in half. Then each of these bent parts of the ears must be bent back, deployed and flattened. At the same time, the upper part of each ear will be bent forward, on the muzzle, giving it a funny look. It remains to draw on it the necessary details with a felt-tip pen.
To make the puppy’s body, fold the square along the vertical diagonal and expand it, only by plotting the fold line. Now she needs to lay the sides to the center. Only, unlike the manufacture of the body of other figures, it is necessary to start the bends not from the upper corner, but by slightly departing from each of them along the side - 3-4 cm. Bend the triangle formed at the bottom back. To give stability to a paper toy, bend down the two lower corners of the workpiece. Then these bends should be straightened and the corners should be bent along the formed lines into the body. The upper corner of the workpiece must also be bent back.

Glue the head part to the upper part of the body part and draw your claw fingers with claws in the lower part of the body.

Pin
Send
Share
Send