In this review, the author tells how to glue the mirror flush with the finishing material (ceramic tiles or porcelain tiles), which is already laid on the wall.
This work is carried out in two stages. At the first stage, it will be necessary to prepare the base to which the mirror will be mounted. At the second stage, the mirror itself is already being mounted.
At the same time, preparatory work is also divided into two main stages. At the first stage, it will be necessary to make beacons from tile glue. The second stage is the tightening of the wall with tile adhesive over previously installed beacons.
Progress
Since the surface of the wall was completely primed before laying the tiles, then re-priming it does not make sense. It is enough just to dust the surface well.
At the next stage, we make beacons from tile glue. For this, the author uses a malk made of a rule and a piece of a metal plate.
After drying the tile adhesive, we remove the formed "snot" with a grater with sandpaper. Next, we dust off the entire surface again and after that we tighten the plane with tile glue along the beacons.
Next, we grind the surface with sandpaper, remove dust and ground it. We wait 4 hours until the primer dries.
Then degrease the back side of the mirror and apply special glue with thin continuous strips. But there is no need to overdo it with glue.
For details on how to glue the mirror in the same plane with the tile, see this video.
